Kobe CH2236SQ-1 User Manual download pdf (Page 11)

UNDER CABINET INSTALLATION

Preparation before Installation

NOTE: TO AVOID DAMAGE TO YOUR HOOD,

PREVENT DEBRIS FROM ENTERING THE

VENT OPENING.

Decide the location of the venting pipe from the

hood to the outside. (Figure 1)

A straight, short vent run will allow the hood to

perform more efficiently.

Try to avoid as many transitions, elbows, and long

run as possible. This may reduce the

performance of the hood.

Temporarily wire the hood to test for proper

operation before installing. If the hood does not

operate, check the circuit breaker or house

fuse. If the hood is still not working,

disconnect power supply and check the

continuity of all wire connections.

Peel protective film off the hood (if any).

Use duct tape to seal joints between pipe sections.

For installing under the cabinet with recessed

bottom, attach 4-inch wide wood filler strips (not

included) on each side. (Figure 2)

Using reference on Page 20-21 to measure and

create access opening for electrical wires and

exhaust under the cabinet.

Vent option installation

CAUTION:

USE HAND TOOLS ONLY. DO NOT

OVER TIGHTEN SCREWS. IT MAY CAUSE DAMAGE TO

THE HOOD.

1. Choose the require vent option. Some installation

screws are already pre-attached to hood.

2. For 6” Round vent installation only:

The 6” exhaust is already attached. (Figure 3)

Align and secure the 6” Round Plastic Collar {F}

to two screws on hood.

3. For Top 3-1/4” x 10” vent installation only:

Remove attached 6” exhaust and discard.

(Figure 3) Keep 13 screws to install 3-14” x 10”

exhaust & vent cover.

Align and secure Top Vent Cover {E} and 3-1/4”

x 10” Exhaust {D} using 14 screws (13 screws

taken from 6” exhaust. (Figure 4)

4. For Rear 3-1/4” x 10” vent installation only:

Remove attached 6” exhaust and discard.

(Figure 3) Keep 13 screws to install vent covers.

Remove duct knockout from back of the hood

and discard. (Figure 5) Unscrew 3-1/4” x 10”

Vent Cover from rear exhaust (located inside

hood); keep screws to install 3-1/4” x 10”

exhaust.

Figure 1

Figure 2

Figure 3

Figure 4

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Comments to this Manuals

No comments

Kobe CH2236SQ-1 User Manual Page 11

Comments to this Manuals

Related products and manuals for Cooker hoods Kobe CH2236SQ-1