Kobe CH2236SQ-1 Manual download pdf (Page 14)

11

WALL MOUNT INSTALLATION

***This installation requires purchase of duct cover Model No. CH1120DC-1.

Preparation before Installation

NOTE: TO AVOID DAMAGE TO YOUR HOOD,

PREVENT DEBRIS FROM ENTERING

THE VENT OPENING.

-

Decide the location of the venting pipe from

the hood to the outside. Refer to Figure 10.

-

A straight, short venting run will allow the hood

to perform more efficiently.

-

Try to avoid as many transitions, elbows, and

long run as possible. This may reduce the

performance of the hood.

-

Temporarily wire the hood to test for proper

operation before installing. If the hood does

not operate, check the circuit breaker or

house fuse. If the hood is still not working,

disconnect power supply and check the

continuity of all wire connections.

-

Peel protective film off the hood (if any).

-

Use duct tape to seal the joints between pipe

sections.

-

If necessary, prepare back wall frame with

cross framing lumber for secure installation.

Using references on Table 2 and

measurements on page 20-22, decide the level

of the lumber. Refer to Figure 11.

Vent option installation

CAUTION:

USE HAND TOOLS ONLY. DO

NOT OVER TIGHTEN SCREWS. IT MAY CAUSE

DAMAGE TO THE HOOD.

1. Choose the require vent option. Some

installation screws are already pre-attached to

hood. Refer to Figure 16. Please use Screws

Package {J} with pre-attached screws for wall

mount installation.

2. For 6” Round vent installation only:

-

The 6” exhaust is already attached. (Figure

12) Align and secure the 6” Round Plastic

Collar {F} to two screws on hood. Follow

instructions in Step 5 to attach Hood

Mounting Bracket {K} and two Duct Cover

Support {L} (Figure 16)

3. For Top 3-1/4” x 10” vent installation only:

-

Remove attached 6” exhaust and discard.

(Figure 12) Keep 13 screws to install 3-14” x

10” exhaust & vent cover.

-

Align Top Vent Cover {E} and 3-1/4” x 10”

Exhaust {D}. (Figure 13) Skip to Step 5 to

attach Hood Mounting Bracket {K} and two

Duct Cover Support {L} using 14 screws (13

screws taken from 6” exhaust. (Figure 16)

Figure 10

Figure 11

Figure 12

Figure 13

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Comments to this Manuals

No comments